WHEELSCLINIC
How to change the coolant in my car
Are you replacing the same type of coolant that it had, and are you doing it before any corrosion or contamination occurred, replace any questionable hoses, fill radiator and reserve: although on some cars you should open some bleed screws to let out trapped air.
Are you replacing an unknown product with an OAT formulation? Then after draining (with heater valve in hot position), you should fill with water, run it until it is hot (without a cap), and drain, check hoses, then fill with your fresh coolant, bleed, etc.
If you are replacing plain water, or coolant that has been neglected, after draining (heater valve open) fill with a liquid commercial cooling system flush product, follow instructions, then rinse, check hoses, and fill, as before. I say liquid flush product as I’ve seen too many systems where the solid does not dissolve and ends up in the water pump.
Do not leave the cleaning product in for days, or you may be missing key parts if they dissolve. Note the missing thermostat seal from the above engine.
If you are diluting your own concentrate, use distilled water, not tap water, as the tap water container chlorine and minerals that will react with parts of the engine or radiator, or fall out of the mix and damage the water pump bearing or seal.
-
AVIATION4 years ago
Photo News: Air Peace commence flight operations to South Africa
-
Car News4 years ago
Polestar is recalls over 2000 electric cars due to software bug
-
Technology4 years ago
Common mistakes in CO₂ emissions calculations
-
Car News5 years ago
Suzuki’s 2020 V-Strom 1050 goes high-tech in high style
-
AUTO STAKEHOLDER4 years ago
FRSC COMMENCES ENFORCEMENT OF NATIONAL IDENTIFICATION NUMBER IN DRIVER’S LICENCE PROCESSING
-
SAFETY / CAR CARE4 years ago
Handbrake warning light; what it means and what to do
-
Reviews4 years ago
IVM Caris Specification: Grand Price for Big Brother Naija IVM Challenge
-
WHEELSCLINIC8 years ago
Chinese-built railway turns tourist attractions in Kenya